Reply to Thread

Send me an email and I'll pass it along.

Originally Posted by DWuthrich

Do you have access to the ALC website? They started shipping the controllers after a certain serial number that needed a specific new driver from the site, rather than just the standard ZNPlus driver from earlier releases. I worked with ALC for almost 15 years and never bricked a controller, no matter how hard I tried. You might just need this updated driver (of which I no longer have access). Good luck!


Sent from my iPhone using Tapatalk

You obviously weren't trying hard enough. Remember how to brick a ME-LGR?

I'll see if I can procure it.


Sent from my iPhone using Tapatalk

Originally Posted by MaxBurn

Seconded, I ran into this as well. The new ZN modules are shipping with updated hardware which requires a 6.xx.xxx module driver.

Basically the stance of ALC is always use the latest module driver available. According to them it isn't a problem to use a 6.xx.xxx driver in older versions of WebCTRL either so even if you are on 4.1 you can use whatever the newest driver they post is.

I don't have access to their website. Do you have the latest driver?

Seconded, I ran into this as well. The new ZN modules are shipping with updated hardware which requires a 6.xx.xxx module driver.

Basically the stance of ALC is always use the latest module driver available. According to them it isn't a problem to use a 6.xx.xxx driver in older versions of WebCTRL either so even if you are on 4.1 you can use whatever the newest driver they post is.

Do you have access to the ALC website? They started shipping the controllers after a certain serial number that needed a specific new driver from the site, rather than just the standard ZNPlus driver from earlier releases. I worked with ALC for almost 15 years and never bricked a controller, no matter how hard I tried. You might just need this updated driver (of which I no longer have access). Good luck!


Sent from my iPhone using Tapatalk

This one is after I formatted with address dial at 0,0.

Here are the images again:

ZN341V+ wrong driver issue

Hi Guys,

I am getting "Wrong Driver" error while setting up ZN341V+ with WebCtrl 5.5. Modstat report shows:



Does anyone have updated driver for this?

I formatted the controller several times and tried to load the driver I have from my server but then I got "Communication Failure" error.

Then out of frustration I formatted one of the 341v+ with address dials at 0,0. Now I am getting this:



Can this be brought to life again? The error light is on and the run light is flashing rapidly. I think the manual says that means it's in Boot Mode.