Post a reply to the thread: Volume Damper Design
You may choose an icon for your message from this list
Please enter the name by which you would like to log-in and be known on this site.
Please enter a password for your user account. Note that passwords are case-sensitive.
Please enter a valid email address for yourself.
Will turn www.example.com into [URL]http://www.example.com[/URL].
cool website , meplumber ! thanx again
Another option is www.physicsforums.com. They have a Mechanical Engineering section in there. Simpler is better. Do use all a favor and keep in the back of your mind, the poor technician that will one day have to replace the actuator or the connecting rod. Good Luck
Thanx Vinster, i'll give it a shot.
You should probably go to an engineering forum. Try http://www.eng-tips.com I'd go the route of the least blades in the airflow and for the handle mounting location, I have seen them positioned in the middle and top or bottom. I doesn't really make a difference to me
Volume Damper Design Hello people; first, i have spent some time trying to figure out which forum to post my question at, and i hope this is correct. Please remove it in case i was wrong. i hate breaking the rules Well, i'm working on a project of manufacturing an in-house volume control dampers, i'm working on the design now and it's almost done. However, i'm still stuck at some points without any answers: 1- how to decide proper number of blades ? (in case of having diffrent widths, e.g.: either 5 blades of 4" or 4 blades of 5") 2- how to decide where to place the extended shaft or the manual handle, top balde or center or bottom ? based on what. Thanx in advanced guys.
Volume Damper Design
Forum Rules