Post a reply to the thread: Turbocor TT300 Bearing Calibration issue
You may choose an icon for your message from this list
Please enter the name by which you would like to log-in and be known on this site.
Please enter a password for your user account. Note that passwords are case-sensitive.
Please enter a valid email address for yourself.
Will turn www.example.com into [URL]http://www.example.com[/URL].
Downlaod the latest version of 3G, I believe they had some issues with the earlier version of 3G, not sure if that was part of it
thanks for reply- actually version 66 and version 80 do work. still unable to get 3g to work but i think its my laptop because it works fine on another one Originally Posted by hookjaw24 use the version 80 software/monitor package. I have had the same issues with 83 and 86 software-went back to 80 and everything went fine. Recently loaded 3g, but haven't used it to calibrate yet, so no experience.
use the version 80 software/monitor package. I have had the same issues with 83 and 86 software-went back to 80 and everything went fine. Recently loaded 3g, but haven't used it to calibrate yet, so no experience.
Yes, liquid slugging causes calibration problems. Evacuate compressor and retry.
Make sure yor com cable to your micro is unplugged
Check earlier t-cor threads,several have stated that they had issues with liq. ref. causing calib. problems,may have to isolate comp. recover gas and then calibrate.
Troubleshooting bearing calibration Please find this Bearing Calibration Troubleshooting section of interest.
Troubleshooting bearing calibration
Calibration and Troubleshooting The attached information sheets may be of value to you in the calibration and / or troubleshooting the bearing calibration issue. These sheets are from a largermanual.
Calibration and Troubleshooting
Turbocor TT300 Bearing Calibration issue I have never had this issue before so if anyone has experience with this I would greatly appreciate any suggestions. TT300 - trying to prepare for an initial start up. During the initial bearing calibration it goes thru all the steps and then fails at the end during shaft levitation. Calibration Failed (Levitation) is the message displayed. Also, the calibration does not sound the same as I am used to hearing the knocking and pinging. I have the modbus disconnected. Im in calibration mode. Also i did try this is the latest 3g software and the previous version with the same results.
Turbocor TT300 Bearing Calibration issue
Forum Rules