Post a reply to the thread: Trane varitrac III and Jace
You may choose an icon for your message from this list
Please enter the name by which you would like to log-in and be known on this site.
Please enter a password for your user account. Note that passwords are case-sensitive.
Please enter a valid email address for yourself.
Will turn www.example.com into [URL]http://www.example.com[/URL].
Varitrac isn't (comm5) or Lon the interface between the Tracker and Varitrac is Lon and any other devices outside of the Varitrac system are also Lon ie: other stand alone rtu's, mp503's, and so on.
Can't you eliminate the CCP and just bring the dampers and RTU into the Jace via Lon if Comm5 or a driver if Comm4? And can anyone tell me when Varitrac became Comm 5 instead of Comm 4?
Thank You mallron
Originally Posted by mechdorn What does that mean? It's 2013 not 2003. The Reliatell unit controller was never intended for integration either. Guess what, I can purchase a LON board or a BACnet board for it today. Why not do the same for the CCPIII. Just rip me off like Trane does with everything else and let me pass onto the end user. #1-cool your jets #2-think about what you just said, if you can get a LON board for the unit then it WAS intended for integration. #3-Trane does not offer a LON or BACnet option for the CCPIII because it's firmware/hardware does not support them because...drum roll please....IT WAS NEVER INTENDED FOR INTEGRATION!!!!!!!! #4-That's what it means.
Originally Posted by mallron never intended for integration either. What does that mean? It's 2013 not 2003. The Reliatell unit controller was never intended for integration either. Guess what, I can purchase a LON board or a BACnet board for it today. Why not do the same for the CCPIII. Just rip me off like Trane does with everything else and let me pass onto the end user.
Originally Posted by mechdorn No integration = no CCPIII. That's the building owner, can't blame him. That's cool, but the VAV's were never intended for integration either.
Originally Posted by controldude CCPIII was never intended for integration! No integration = no CCPIII. That's the building owner, can't blame him.
Originally Posted by controldude CCPIII was never intended for integration! And that is a sham, because it is a pretty good zone control panel. Way to go Trane!
CCPIII was never intended for integration!
Trane varitrac III and Jace It's been a couple years since my last attempt at this. It was a total disaster last time, was wondering if any improvements with newer revisions to each component. I used the Trane LNML file provided by Tridium last time, all I got was a bunch of unusable data. Any input appreciated.
Trane varitrac III and Jace
Forum Rules