Reply to Thread

Seems like everyone has the high lumen led flashlights now, could you imagine the reflections. But its coming along great.

Originally Posted by LibertyTree

Diamond Plate!!

Yeah! haha

Diamond Plate!!

the diamond plate i think was actually aluminum, we mounted a 4x8 sheet of the plate to plywood and it's mounted and anchored to the wall but with a 1/2" gap so as to avoid moisture issues

thanks for looking

Looks good how much did the stainless plate cost?

Originally Posted by edbrown

So the white tank is a buffer tank? Is this to increase the water capacity in the system and reduce short cycling?

Installed many Mon/Cons - never with a buffer.

Thermal mass, your correct, if it can't modulate down below the lowest load it will short cycle.

So the white tank is a buffer tank? Is this to increase the water capacity in the system and reduce short cycling?

Installed many Mon/Cons - never with a buffer.

Looks great! The diamond plate is a bit "much" - I guess you can't win. lol

When using teh boiler buddy, stop using the supplied decoupler manifold! Needless extra pump!

I'm thinking that diamond plate wasn't cheap?

Good stuff Cody!

I think your right too, I always use them but after telling you I looked and think I didn't see them either.

Attachment 347671

Originally Posted by Joehvac25

Is that a heat trap instead of a check valve? Looks nice

that wasn't what we were going for.... but sure!

ironically, i looked up the instructions online for the boiler buddy (after my other boiler post) and found nothing noted about check valves either in writing or any of the drawings

thanks for looking!

Is that a heat trap instead of a check valve? Looks nice

Buderus GB142 New Construction

I know many of you busted my hump about not painting the board on this install....

http://hvac-talk.com/vbb/showthread....-Family-Retail

The pics below are of a new construction home being built by a local inspector.

-all in floor
-garage zone has antifreeze and is separated with plate heat exchanger
-boiler buddy
-alpha pump with zones
-indirect dhw


This is still a work in progress but I thought it looks great so far. The water line to the fill for the boiler was installed as a temporary thing by the plumber as he was in a hurry. I didn't do any of the piping but I designed the boiler board and will be completing wiring and start up probably next week. We also have installed a gas furnace, a/c and duct into this house.


Attachment 347631


Attachment 347641