Page 1 of 201 123456781151101 ... LastLast
Threads 1 to 50 of 10049

Forum: Tech to Tech Chat - Residential

FOR TECHNICAL CHAT BETWEEN INDUSTRY WORKERS ONLY. NO AOP OR DIY** This forum is for Technical Chat in the Residential Industry and only within the limits of the Open area Rules concerning DIY. Any technical chat that goes too far will be removed or moved to the Pro Area.

  1. Sticky Thread Sticky Threads

  2. Poll Sticky Thread Poll: Curiosity Question On Brands You Carry

    Started by The Editor, 02-17-2012 04:21 PM
    23 Pages
    1 2 3 4 5 6 ... 23
    • Replies: 289
    • Views: 134,194
    06-27-2018, 03:56 PM Go to last post
  3. Sticky Thread NO AOP posts here please. ONLY Tech to Tech chatter

    Started by Dad, 08-10-2011 04:34 PM
    • Replies: 0
    • Views: 13,845
    08-10-2011, 04:34 PM Go to last post
  1. Normal Thread Normal Threads

    • Replies: 67
    • Views: 1,362
    Today, 09:17 AM Go to last post
  2. Wiring Copeland Compressor

    Started by town, Yesterday 10:57 PM
    • Replies: 4
    • Views: 115
    Today, 09:09 AM Go to last post
  3. "on" vs "auto" in cooling mode & humidity

    Started by Grawburg, 08-13-2018 08:13 PM
    2 Pages
    1 2
    • Replies: 20
    • Views: 517
    Today, 07:53 AM Go to last post
  4. Blower motor turns on & off every 3 minutes???

    Started by Mrak, Yesterday 11:29 AM
    • Replies: 9
    • Views: 188
    Today, 06:55 AM Go to last post
  5. What's wrong with this installation?

    Started by kdang, 08-02-2018 12:55 AM
    3 Pages
    1 2 3
    • Replies: 36
    • Views: 1,441
    Today, 05:59 AM Go to last post
  6. New TEchnician

    Started by John Crossman, Yesterday 01:25 PM
    • Replies: 10
    • Views: 210
    Today, 12:36 AM Go to last post
  7. Mis Matched System

    Started by joemach, 08-15-2018 06:36 PM
    • Replies: 11
    • Views: 208
    Yesterday, 08:57 PM Go to last post
  8. Second Opinion - R22 - Piston

    Started by redstone85, 08-15-2018 07:57 PM
    • Replies: 11
    • Views: 216
    Yesterday, 08:40 PM Go to last post
  9. Bad Compressor or TXV??

    Started by smadave, 08-14-2018 09:43 AM
    2 Pages
    1 2
    • Replies: 22
    • Views: 558
    Yesterday, 01:01 PM Go to last post
  10. Compressor occasionally pulls LRA

    Started by Raehvac, 07-10-2018 10:31 AM
    2 Pages
    1 2
    • Replies: 16
    • Views: 756
    Yesterday, 12:25 PM Go to last post
  11. HW coil controls

    Started by taylor2, 08-15-2018 10:29 PM
    • Replies: 6
    • Views: 134
    Yesterday, 12:23 PM Go to last post
  12. Multi - head conventional air conditioner

    Started by Mattmm, 08-14-2018 02:48 PM
    • Replies: 7
    • Views: 201
    Yesterday, 10:44 AM Go to last post
  13. Airflow per room

    Started by hammersheating, 05-10-2018 02:15 AM
    2 Pages
    1 2
    • Replies: 21
    • Views: 818
    Yesterday, 10:20 AM Go to last post
  14. What is better quality Goodman or Ruud

    Started by kb3ffh, 08-13-2018 07:54 PM
    2 Pages
    1 2
    • Replies: 14
    • Views: 511
    Yesterday, 09:32 AM Go to last post
  15. Schrader valve core remover, $ or $$$

    Started by kb3ffh, 03-10-2018 09:45 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,426
    08-15-2018, 10:41 PM Go to last post
  16. Suction Line Trap - Necessary?

    Started by raulsteichen, 08-12-2018 05:48 PM
    3 Pages
    1 2 3
    • Replies: 32
    • Views: 699
    08-15-2018, 09:08 PM Go to last post
  17. Bosch HP Accelerated Cooling

    Started by Achso017, 08-14-2018 10:08 PM
    • Replies: 2
    • Views: 163
    08-15-2018, 07:22 AM Go to last post
  18. Proper Combustion Air For Garage Installation

    Started by James Colver, 08-11-2018 05:56 PM
    2 Pages
    1 2
    • Replies: 24
    • Views: 488
    08-14-2018, 02:25 PM Go to last post
    • Replies: 22
    • Views: 909
    08-14-2018, 09:37 AM Go to last post
  19. Btu's needed.

    Started by Cool_man, 08-13-2018 03:53 PM
    • Replies: 3
    • Views: 133
    08-13-2018, 09:16 PM Go to last post
  20. Haleyville AL

    Started by gsxrsquid, 08-13-2018 08:35 AM
    • Replies: 1
    • Views: 149
    08-13-2018, 05:51 PM Go to last post
  21. Question Furnace cfm and temperature rise

    Started by calcs, 08-12-2018 09:07 PM
    • Replies: 5
    • Views: 184
    08-13-2018, 04:59 PM Go to last post
  22. Having to pay shipping cost for warranty parts from my distributor

    Started by HVAC/Stud, 02-08-2013 04:54 PM
    2 Pages
    1 2
    • Replies: 20
    • Views: 3,645
    08-13-2018, 04:43 PM Go to last post
  23. How many btus needed?

    Started by Cool_man, 08-13-2018 01:27 AM
    2 Pages
    1 2
    • Replies: 13
    • Views: 267
    08-13-2018, 04:15 PM Go to last post
    • Replies: 2
    • Views: 171
    08-13-2018, 12:04 PM Go to last post
  24. Draft control

    Started by icy78, 08-06-2018 03:48 PM
    4 Pages
    1 2 3 4
    • Replies: 41
    • Views: 725
    08-13-2018, 08:17 AM Go to last post
  25. Will R407c Work In A R410a Condenser?

    Started by VA99HC, 08-09-2018 06:53 PM
    • Replies: 7
    • Views: 402
    08-13-2018, 07:04 AM Go to last post
    • Replies: 1
    • Views: 145
    08-12-2018, 06:19 PM Go to last post
  26. New Residential Build

    Started by Badams1229, 08-02-2018 09:06 AM
    • Replies: 7
    • Views: 492
    08-12-2018, 02:54 PM Go to last post
  27. Worst/ most costly mistake you've made on the job?

    Started by Bvo27, 03-12-2017 10:02 AM
    14 Pages
    1 2 3 4 5 6 ... 14
    • Replies: 175
    • Views: 22,366
    08-12-2018, 11:46 AM Go to last post
    • Replies: 3
    • Views: 441
    08-12-2018, 04:47 AM Go to last post
  28. opinions on navien equipment

    Started by probverb27:17, 10-28-2015 09:39 PM
    • Replies: 12
    • Views: 1,873
    08-12-2018, 12:43 AM Go to last post
  29. What happens when you replace a 1T RV with a 2T?

    Started by Raehvac, 08-10-2018 05:24 PM
    • Replies: 5
    • Views: 238
    08-11-2018, 08:57 PM Go to last post
  30. System blowing warm air when low on R22 - confused.

    Started by Buckeye88, 08-06-2018 08:32 PM
    3 Pages
    1 2 3
    • Replies: 34
    • Views: 1,023
    08-11-2018, 08:12 PM Go to last post
  31. Soldering Lineset?

    Started by Iceman_pdx, 08-10-2018 09:10 PM
    • Replies: 5
    • Views: 318
    08-11-2018, 09:47 AM Go to last post
  32. Refrigerant contaminated?

    Started by josegarcia, 08-10-2018 10:00 AM
    • Replies: 8
    • Views: 344
    08-11-2018, 06:03 AM Go to last post
  33. dnob

    Started by dnob, 08-09-2018 11:34 PM
    • Replies: 10
    • Views: 357
    08-11-2018, 12:37 AM Go to last post
  34. HRV

    Started by Galt, 08-10-2018 04:37 PM
    • Replies: 1
    • Views: 130
    08-10-2018, 04:49 PM Go to last post
  35. who was the guy with all the manuals?

    Started by Raehvac, 08-07-2018 11:38 PM
    2 Pages
    1 2
    • Replies: 19
    • Views: 597
    08-10-2018, 03:30 PM Go to last post
  36. Heat Pump Runs 5 minutes than shuts off 10 minutes

    Started by PointRunner, 08-08-2018 06:29 AM
    2 Pages
    1 2
    • Replies: 22
    • Views: 540
    08-10-2018, 10:33 AM Go to last post
  37. Natural Gas detector

    Started by chill1986, 08-09-2018 05:20 PM
    • Replies: 4
    • Views: 210
    08-09-2018, 09:46 PM Go to last post
  38. CFM Blower data

    Started by Kevin Waeyaert, 08-07-2018 11:06 AM
    • Replies: 6
    • Views: 274
    08-09-2018, 02:05 PM Go to last post
  39. Manual and nameplate say different things

    Started by Raehvac, 08-09-2018 12:09 PM
    • Replies: 1
    • Views: 158
    08-09-2018, 12:36 PM Go to last post
  40. TXV SH 28 degrees Carrier AC

    Started by colnago, 08-07-2018 09:11 PM
    • Replies: 4
    • Views: 284
    08-08-2018, 10:11 AM Go to last post
  41. Settle an augument

    Started by rickinva804, 08-07-2018 10:39 PM
    • Replies: 6
    • Views: 382
    08-08-2018, 09:00 AM Go to last post
  42. Company Provided Tools

    Started by Jlcook00, 08-05-2018 12:23 PM
    3 Pages
    1 2 3
    • Replies: 30
    • Views: 1,007
    08-08-2018, 05:25 AM Go to last post
  43. Furnace service work

    Started by Blastbark, 08-07-2018 01:38 AM
    • Replies: 4
    • Views: 353
    08-07-2018, 11:57 AM Go to last post
  44. Mitsubishi MSZ12UN condensation leak

    Started by wec1951, 08-06-2018 12:23 PM
    • Replies: 2
    • Views: 173
    08-07-2018, 06:47 AM Go to last post
  45. Trying New Items : Any Of these Tested ?

    Started by QualityAssure, 08-03-2018 01:20 PM
    • Replies: 5
    • Views: 443
    08-06-2018, 08:36 PM Go to last post
  46. Struggling with TXV issues

    Started by Santafebob, 08-06-2018 05:10 PM
    • Replies: 2
    • Views: 288
    08-06-2018, 08:33 PM Go to last post

Page 1 of 201 123456781151101 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 20 replies or 150 views
Hot thread with unread posts
More than 20 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.