georgelass
12-24-2011, 12:24 AM
This probably doesn't come up for most folks, but if you ever strip
the threads for the motor mount holes in a blower housing (for a Bryant and possibly
others), don't bother worrying about tapping new threads in new holes.
The factory doesn't tap threads. Just put the same bolts in new holes.
I am supposing they are self-tapping because it works out just fine.
(For the record, I am not ham-fisted and did NOT strip any threads.)
I hope this helps.
the threads for the motor mount holes in a blower housing (for a Bryant and possibly
others), don't bother worrying about tapping new threads in new holes.
The factory doesn't tap threads. Just put the same bolts in new holes.
I am supposing they are self-tapping because it works out just fine.
(For the record, I am not ham-fisted and did NOT strip any threads.)
I hope this helps.