lonspec/lonstation pcc10 card

[Dilp172]

lonspec/lonstation pcc10 card
I'm trying to test my echelon pcmia network interface card using lonspec/lonstation and in trying to direct connect to a h-well lon vav controller.The problem i have is the software wont see the device,i installed echelons driver before inserting the card/i belive i 'm setup correctly on the h-well side any ideas?
i did test the card several times via the echelon test function and usually it test ok,but occasionally it shows a buffers full fault

[short243]

Hi, What version of windows. If you go to control panel do you see an icon for lon, Lonworks plug and play. Check your settings. don't have a computer with me but near top on left, there are choices, if I remember right it is the one starting with "n" or #10. Just been to long since I looked to remember.

[lwarren]

Make sure your Lonworks Plug N Play NI is set to PCC10L7

[Dilp172]

Thanks,plug and play was set wrong.