PDA

View Full Version : Evolution Control does not register low run times


markis7
09-24-2005, 12:51 AM
I have the following setup:

Bryant 355 furnace, 598 two-stage condencing unit and Evolution Control.

I wanted to check AC usage via Evolution Control (Advanced Menu/Service/Run/Fault History), but it only shows high cool numbers, zero for low cool.

In fact, AC Unit seems to cycle between low and high speed normally.

Anybody else has or had the same problem?

Thanks

[Edited by markis7 on 09-24-2005 at 12:58 AM]
jrbenny
09-24-2005, 10:02 AM
It's a known software glitch. Outdoor unit doesn't report run times correctly to the Infinity User Interface. It has no bearing on the system performance. Before you ask, there is not a software patch to correct it.
markis7
09-24-2005, 01:42 PM
I see.
Anyway, just out of curiosity how is software update performed?

Thanks
jrbenny
09-24-2005, 02:56 PM
It's not. UI is not capable of receiving new software.

[Edited by jrbenny on 09-24-2005 at 07:38 PM]
markis7
09-24-2005, 07:10 PM
What is UI?
jrbenny
09-24-2005, 07:38 PM
the thing on the wall. user interface.
markis7
09-28-2005, 12:23 AM
Someone's system reports correct numbers according to this thread:

http://www.hvac-talk.com/vbb/showthread.php?postid=861403#post861403

I asked my installer to replace evolution control and he did. It still reads only high run times.

[Edited by markis7 on 09-28-2005 at 12:27 AM]