View Full Version : Blackhawk/Proto
06-08-2011, 05:27 PM
I used to think Blackhawk/proto was decent stuff. Very light tapping from a hammer did a number on these punches. Anyone else have similar issue with there punches?
06-08-2011, 05:41 PM
Are those for punching out crooked holes?
I purchased a punch not too long ago to remove the race from rear wheel bearings and it did the same thing except the end rounded out with just a few hits then started to bend. Don't know the make but looks the same.
Seems none of this stuff is make to last even from one use anymore.
06-08-2011, 06:37 PM
I always liked Proto as well.
For the money at least Craftsman is still decent.
I guess we will all have to go Snap On , Mac , Matco in the future.
And resemble auto mechanics.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.