another week at 911

[billygoat22]

Got a bit more work done this week. Set three a/hs, finished the duct for units in mech room. Pics don't to that mass of duct justice, looks like its tied in a big knot! May try a shot from floor.

http://www.imagewiz.net/usr/hvac1/14852_911_032.jpg

refer lines are all guy I work with, I did some tricky fitting together of duct meanwhile.
http://www.imagewiz.net/usr/hvac1/14853_911_033.jpg


Stared this Thursday, 10ish today he finished the lines inside and came out to run some piping.

http://www.imagewiz.net/usr/hvac1/14854_911_030.jpg

Knew this corner was going to give me trouble from day one

http://www.imagewiz.net/usr/hvac1/14855_911_031.jpg

[hvac hero]

Very nice job. I loved how neat that copper runs through the wall. Too bad they dont let yall use a half inch liner on the inside of that duct. All the prints we go by require that. Very nice job.

[billygoat22]

I was looking at those return boxes when I put them in and thinking, that'll be tore up in no time.

Prints call for 2" wrap throughout the building.

[BaldLoonie]

Better get them chained down so you don't lose them :D

[square2round]

Nice job. Very nice.

[billygoat22]

They should be safe. Bolted down the minisplits and the condensors are brazed in. GC wanted units on site a week ago and took responsibility for any theft.




Jail and courthouse are right next door so plenty of "heat" coming and going all the time.

[mayguy]

Looks good.. This a Heat Pump system?


Like to see the pix when you are all done!

[joker1]

Whats that lone 3/8 line above the other line sets?

[Jultzya]

The last two LL's are not done, so I take it that line is the next LL to be getting installed.

Nice looking job!