Getting run over by a trane

[AndyT]

I'm an installer, maint guy on a small campus. How do I get started in the controlls on a trane tracer summit system? I understand and use the basic end user stuff, but as a tech I am now running into controll issues. I am on my 4th boss in 5 years and now the knowledge through experience setting the system up is lost. (My boss is supposed to be responsible for the operation of the system, but does not know basic refrigeration principals) so... here i am looking to program different aspects of our system but am at the mercy of trane tech services. where do i start to take the reigns on this trane going off the rails?

[timebuilder]

I'm an installer, maint guy on a small campus. How do I get started in the controlls on a trane tracer summit system? I understand and use the basic end user stuff, but as a tech I am now running into controll issues. I am on my 4th boss in 5 years and now the knowledge through experience setting the system up is lost. (My boss is supposed to be responsible for the operation of the system, but does not know basic refrigeration principals) so... here i am looking to program different aspects of our system but am at the mercy of trane tech services. where do i start to take the reigns on this trane going off the rails?

I would say that a Tracer Summit class is in order.

[mallron]

I would say you need to set-up remote access and pay me to train you! :whistle:

[supertek65]

knowing controls means knowing all controls.
building automation and the actual controls!

Unfortunately controls are all proprietary!

that means getting service tools , software and hardware for each and every brand of controls!

as timebuilder said above, just get with your local TRANE wholesaler and get signed up for all the TRACER classes you can!

I would also suggest hanging out here on this site in the CONTROLS forum!!!!!!!!!

those dudes are hella smart and if you can get in with a couple of them they will help you and send you cool stuff!

Frank

[AndyT]

thanks, its just a little overwhelming to have such a blind spot in your perspective trade. since my post i have found the rover tool. it hasn't been updated since 07, but hopefully i can plug in a few places and get my toes wet. and classes will be a must. thanks.

[Phisher]

It would be worth your time and money to have Trane perform some onsite training. That way you can get some training on the controls specific to your job site and they can review operation and check for updates. It's time for an experienced conductor to help you keep this Trane on the rails.