PDA

View Full Version : York screw oil change



bobby m
07-02-2010, 02:54 PM
Looking for a little advice,do you guys pull the charge to change oil or do you pump oil into tanks using recovery machine

servicetrane
07-02-2010, 03:55 PM
which model of machine is?

bobby m
07-02-2010, 04:36 PM
My brain fart it's a ysda approx. 200 ton water cooled,with single comp. and oil separator.

servicetrane
07-02-2010, 04:44 PM
to drain the oil pressure of equipment and oil Gargar uses a hand pump oil, now if what you want is to recover this oil in the evaporator refrigerant reclaimer used with the machine stop

bobby m
07-02-2010, 05:41 PM
:bsing: t Thanks amigo

absrbrtek
07-02-2010, 06:32 PM
Two 125 pound cylinders with a recovery machine gets you compliant. That is what I use, then once refrigerant is recovered from the cylinders, pump up with nitro and blow oil into drums. Get machine hot before oil change by running, youll get less refrigerant with the oil. JMHO

cperk
07-02-2010, 11:45 PM
to drain the oil pressure of equipment and oil Gargar uses a hand pump oil, now if what you want is to recover this oil in the evaporator refrigerant reclaimer used with the machine stop

HUH? Do what absrbrtek said, but I take two 100lb cylinders, pull a deep vac. on both. Leave press on seperator , cylinders will suck oil right in. Then you can pump oil back in with hand oil pump. Take cylinders back to shop and reclaim refrigerant from vapor valve on tank. Then push oil out with nitrogen like absrbrtek said. Hey absrbrtek, this is not Lib, how you know this?

york56
07-03-2010, 08:27 AM
You have to know the secret hand shake.:whistle:

heavymetaldad
07-03-2010, 08:35 AM
kinda like this, but a little different................
http://www.youtube.com/watch?v=_N-h4D-wSak

york56
07-03-2010, 08:40 AM
Yea thats the ticket.:bsing:

OSR
07-03-2010, 08:46 AM
HUH? Do what absrbrtek said, but I take two 100lb cylinders, pull a deep vac. on both. Leave press on seperator , cylinders will suck oil right in. Then you can pump oil back in with hand oil pump. Take cylinders back to shop and reclaim refrigerant from vapor valve on tank. Then push oil out with nitrogen like absrbrtek said. Hey absrbrtek, this is not Lib, how you know this?
Hes been doing this probally as long as some of us have been alive ....... :D

bobby m
07-03-2010, 09:45 AM
Thanks guys have a safe 4th,turn all phones off.

stickerhead
07-04-2010, 11:04 AM
First, why are you changing it? Contaminated? Blow it out, pump it in!