Chrysler Centrif.

[paulj]

Looking for a schematic for a Chrysler C2, vintage 1972.
I've run out ideas

[hw chiller man]

DO you have a problem with the chiller. Its been 10 years since I have serviced one of these. Don't know how good my memory is.

[paulj]

Just trying to get the sequence and switching of the TR2 timer so we can replace it.

[RichardL]

Ahhh...The famous Chyrsler "WhirlPack" ......

Unique in many ways...

The tubes in both the Condenser & Evaporator are 3/4"OD on one end and necked down on the opposite end to 5/8"OD..
Just imagine for a moment the problems involved in re-tubing that Puppy...A blooming nightmare it is..

A Modutrol motor linked to a Ball-Valve on the liquid line thru an adjustable slot and a float switch to try and have some semblance of Level control.

Most used GE motors that had a bad habit of the Iron on the rotor walking and relocating itself knocking out the thrust bearings...Embarrasing to replace the 3k$ bearings and have them eat themselves as soon as motor transitioned...

I'm sure I have the books in me spare bedroom...That has now been dedicatede to a Puter' room for me twin Grandsons.
But....at the present time it is if I have a gigantic magnet in my back pocket....holding my butt to this chair...I will look...later...Kk...

[hw chiller man]

I take my hat off to you sir Richard if you still have those books. Of the nine airtemps that I had under contract I believe 7 of them were converted to 32SM controls. Too hard to get parts for the chrysler controls. I could do a conversion in quicker time than it took to get parts.

[nun]

Let me know if Richard cant find one there is one at this school we just set a McQuay next to it

[no8no3]

You guy's are telling your age.....LOL

[RichardL]

I'm still looking....don't give up on me yet..

[paulj]

I appreciate it Richard

[nun]

Did you get the info you needed?

[sonc]

Originally posted by RichardL
I'm still looking....don't give up on me yet..


richard must of went on a 3 hour cruise...a 3 hour cruise..

[nun]

I have a fairly detailed wiring diagram. Have not done allot of work on them. I will try to scan this 8x14 and e-mail it to you.