View Full Version : Indoor pool heat pump application
05-11-2010, 02:44 PM
I am looking for some advice in selecting a cost effective control system that will control humidity and temperature for an indoor pool room. It must be accessible via the Internet and also local. Programming must be flexible as the sequence of operation could change. The system includes a heat pump, two heat exchangers, boiler, radiant heat, and discharge hot water coil. Points AI-11, DI-7, DO-8, AO-4. I am familiar with the older Honeywell and JCI controls but not the new controls available now from them or other suppliers. Any suggestions?
Thanks in advance
05-12-2010, 02:04 AM
Dig around the Desert-Aire download area. They use JCI's controls for their dehumidification systems. Many manuals and point lists that may help
Check out a Tridium Jace with I/O 34 Module,
it has 16 UI's, 10 DO's, 8 AO's!
05-17-2010, 07:24 AM
Thanks gemo54 and rad1. I am looking into your suggestions.
05-17-2010, 09:32 AM
I've never used them but PoolPak is a company that specializes in this application. If I remember correctly, they were spun off of York befire Johnson took them over.
It doesn't seem like they use an open protocol but who knows, it might still be worth it to skim their website.
05-17-2010, 09:40 AM
Delta make an embedded webserver touchscreen, that coupled with one of their Ethernet capable controller and you are off to the races. Universal IO, free programmable and web based/touchscreen GUI.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.