Repairing leak on U-tube junction

[mcairrepair]

https://lh3.googleusercontent.com/Yz74Wtc-QuZoeYq4OOf0X_JWc4sjGvq6QrLLC5ADeu3rLrVOAmA5d91E_2 gjli8yHiwacAO_v7030-4kKi7lnbiGqg=s512

In the picture above there's a leak on the bottom u-tube on the left connection right where it joins the main liquid line. What is the most efficient way to repair that leak? Can it just be rebrazed or do I have to replace the piping on that section?

[VTP99]

Just clean it up good. I like using a small wire wheel on a drill. Of course clear system and direct your flame away from other welds. Get in and get out with the heat.

[jemawalton]

Flow the whole joint and not just where the leak is or you will end up chasing the leak from one spot to another.

[VTP99]

Flow the whole joint and not just where the leak is or you will end up chasing the leak from one spot to another.

:ditto:

[C-Jac486]

I wouldn't use a wire wheel on a drill..... maybe an old fitting brush or sand cloth.... low heat.... make sure you have the line open so pressure has some where to go.

[John Culpepper]

x2 on the fitting brush. I have an assortment in my torch carrier. Hit it with some disc brake cleaner first to get the oil off (I use that because it cuts the oil and dries quickly) Pull your high side schraeder and use a small tip on your oxy/ac rig.

[johncavh]

sell them a new coil, if repair does not work you will be back.

[vamrat]

I have to agree with johncavh. The coil should probably be replaced. If it is not repaired correctly and there are damages you could end up liable.

[VTP99]

New coil probably as much as new unit.

[btuhack]

Next time you replace a unit, take the opportunity to practice coil repairs on the old one if given the chance. Leaks at the tube sheet always seemed the toughest at first. It's much easier when it doesn't matter.
For now.... clean, oil free, and well sanded makes it easy. have fun

[VTP99]

This repair should be easy. It's not at the sheet were the tube passes threw. As was said earlier clean area well & flux. Like i said in post #2 use a small wire wheel to assist in accomplishing this contrary to C-jac's post. Try it you'll like it.

[C-Jac486]

This repair should be easy. It's not at the sheet were the tube passes threw. As was said earlier clean area well & flux. Like i said in post #2 use a small wire wheel to assist in accomplishing this contrary to C-jac's post. Try it you'll like it.

No need for flux, on copper to copper, unless you plan on using a high silver rod.... even then buy the flux coated rod.... just make sure it's clean and take your time!!