MathMan
03-12-2010, 01:04 PM
I am looking for some info regarding a York N2 Microgateway which lost communication. I stumbled upon a commissioning manual and followed the instructions to reset it but no luck so far. I was able to reset the gateway to standard defaults, by removing power, then the JP7 jumper, then setting node switch to 128, putting the jumper and power back on and waiting until the 3 led flashes per cycle return to 1 led flash per cycle. Only, after I do that, it says that I need to remove power and set node switch to the desired Quick-start profile. In this case I tried the setting 249 (York talk version 6; 1200 bauds, even and 9600 bauds for N2 protocol), but the 10 led flashes per cycle that is supposed to happen actually never happened. It just keeps flashing about once per second.
Can someone help me with that?
Here are all the model numbers I found on the unit:
Unit model: YK CF 07-CP F
Microgateway: 031-02039-001 rev.D
Optiview: GNR-018; Y005016; 031-01730-000; Rev. E
Thanks!
Can someone help me with that?
Here are all the model numbers I found on the unit:
Unit model: YK CF 07-CP F
Microgateway: 031-02039-001 rev.D
Optiview: GNR-018; Y005016; 031-01730-000; Rev. E
Thanks!