Valent Jenesys Controller

[smokeout]

I have stumbled across a Valent(Trane) Jenesys Controller on an ERV. I need to add a CO sensor to the system. Is it possible to add points? It has a LCD on the Jenesys itself and it also has an IO-16 and a IO-34. I have points to spare and have used the UMT tool, but I dont see how to configure a new point. Any ideas?

[smokeout]

:bump:

[Chet1508]

smokeout,

Have you tried contacting the tech support dept from the Manufacture of the the JeneSys Controller:

Lynxspring Inc.
1210 NE Windsor Drive
Lee's Summit, MO 64086
Toll Free Phone: 877-649-5969

They are the manufacturer for the JeneSys Controllers that Valent uses on their ERU's

Hope This Helps,

Chet



I have stumbled across a Valent(Trane) Jenesys Controller on an ERV. I need to add a CO sensor to the system. Is it possible to add points? It has a LCD on the Jenesys itself and it also has an IO-16 and a IO-34. I have points to spare and have used the UMT tool, but I dont see how to configure a new point. Any ideas?

[smokeout]

Yeah, I checked with LynxSpring. Evidently Valent locks these controllers down and will not change it without charging a fee and going through miles of red tape. I went ahead and re-routed some wire pulls and pulled the point in on my IO_34. Thanks though.