Johnson M3 graphics Set up button to display schedule

[Fmech]

I need someone in Johnson land for this. I have a m-3 Graphics GDF display
I want to add a button to basically execute minspecter and then open up the schedule file for that piece of equipment
I already have the schedule set up and the graphics but can't seem to get the punctuation right to open the schedule directly with in this graphic
I have the object name within the BNOPC file but don't know if I need periods
back slashes, colons or what, between the N-30, mexplorer, minspect.exe - schedule - and boiler schedule file name

Any help would be appreciated

Thanx!!!

[kostasgreece]

If it is M3 with N30, you must use an OLE object on Graphic console, that will allow you to embend schedule interface in graphics.

That object is in OLE toolbox, and you must set on its properties the path, as you normally do for points, of respective schedule (without *.present value property).

[billcontrols]

It has been a while, but i seem to remember using mexplorer to display the desired object and then copying the name from a gray area near the top of the window. Then click back to the open drawing in M graphics and paste the object name into the dialog box. I found this was sometimes easier than searching the opc data base tool built into the dialog box.

I don't have the mgraphics available on this computer or I would give some more detail.

Bill