FX03 PointMapping Table

[Automation]

Hi can anyone help me out with a N2 point mapping table for a johnsons FX03.
Can the digital input 4 on a FX03 be used as a monitoring point for eg. Fan status or overheat status?

[OutOfControlMan]

There is no FX03. FX05,07,10,14,16. The point mapping table is built in fx builder and can be set up many different ways.

[DaveCR]

I've never seen one, but the documentation says yes.

[Automation]

I managed to organise the prn file for the FX03. When mapping these points on a NAE, certain paramaters can be configured for the FX03 like timers, deadband, PB and limits.

[mechdorn]

I managed to organise the prn file for the FX03. When mapping these points on a NAE, certain paramaters can be configured for the FX03 like timers, deadband, PB and limits.

What is a FX03? Where did you get a file for it?

[asdf;ljk]

230 VAC fan coil controller sold in Europe and Mideast

[Automation]

What is a FX03? Where did you get a file for it?

The FX03 comes Pre-programmed; all the technician has to do is set a couple of dip switches for the desired control configuration. I sourced the PRN file from the Johnson controls European technical department.

[mechdorn]

The FX03 comes Pre-programmed; all the technician has to do is set a couple of dip switches for the desired control configuration. I sourced the PRN file from the Johnson controls European technical department. Neat, maybe you can manually add BI-4 to the data base and give it shot.

[eceteknik]

Metasys N2 or Bacnet table, which one is your wanted ?
pls send to me a e-mail ,
I can send to you .. table and prn file for NAE ..

eceteknik@yahoo.com