Point in FX40 usually in fault ???

[plasmud]

2 questions, if there is no fault cause and the point jumps in and out of fault all the time, what can be causing the fault? I thought it was bad communication on the N2 but no other points are in fault. It is a AI using 4-20mA

also, is there anyway to stop the point from highlighting itself in orange when in fault in my graphics.
the output number is always correct and updating, just in fault 90% of the time

sorry if this has been addressed in another topic, i didnt see any

[NINAX]

2 questions, if there is no fault cause and the point jumps in and out of fault all the time, what can be causing the fault? I thought it was bad communication on the N2 but no other points are in fault. It is a AI using 4-20mA
Are you sure the AI is within range?


also, is there anyway to stop the point from highlighting itself in orange when in fault in my graphics.
the output number is always correct and updating, just in fault 90% of the time

At the bottom of the bound label binding properties, Status Effect can be Color & Blink, Color, or None.

[tshort]

Change the graphic to look at the out.value not out. This will just display the actual output value and the value plus the status of the point.

[plasmud]

I am using the out/value for the graphic.
the bound label propertys will turn it off but I use that for flashing it red when truly in alarm. so it is a quick fix but not the perfect one.
I do have to check the ranges setup within the DX to make sure that it is in range
Thanx guys