PDA

View Full Version : Gasp! A Goodman job!



BaldLoonie
01-19-2004, 05:31 PM
Disclaimer: I didn't put this here because it is a special job. I just wanted to give Robo's heart a little stress test when he sees we put in a Goodman product!

The old GUN had a split heat exchanger faceplate, rusted shut burners and a very rusty cabinet due to condensate leaks. The supplier gave us some off a new one so we stayed with a Goodman. Seems like a nice unit. Was a bit of a pain since flue, intake, gas & drains all come out the left side. Hard to install the trap with the return there too. Otherwise, clean furnace, easy to install & service. Easy to flip the inducer around.

http://ww2.imagewiz.net/images/hvactalk/14526_Griffin1.jpg

http://ww2.imagewiz.net/images/hvactalk/14527_Griffin2.jpg

selfemployed
01-21-2004, 09:50 AM
Nice changout. Is the red furnace switch plate required where you are? Notice some zoning going on there too.

troyorr
01-21-2004, 08:54 PM
Why didn't you run the coil drain into the same floor drain as the furnace condensate? That long piece of 3/4 pvc is just waiting to get kicked and broken.

jpb2
01-21-2004, 09:44 PM
nice job!!!!! you fab all your stuff ? f.y.i. beware of steel prices. add a little to bids. flats went up 12% this week and our pipe and fittings mfg. send notice about 10-15 % we are all in here to make a living hope this helps. also troll-a- temp zone ?

BaldLoonie
01-22-2004, 07:12 PM
Answers:

No, the red cover plate isn't required. No inpsections, no permits, anything goes.

Good question on the A/C drain. Doesn't make sense to me either. I'll ask!

All metal done on the job. On this job, just a 4" transition on top of the furnace. I got the message about rising prices, so far hasn't hit yet. Yes, an OLD Trol-a-temp panel but not causing any trouble.

MikeJ
01-23-2004, 07:28 AM
I see your two favorite things...the chair and the instructions....which I enlarged and read:

This goes here..and dis goes there....Tighten this about yay much....Put white pipe over dere....

Nice job....that a/c pvc....you gotta xxplain that. Also, no vent on it. Will it drain properly?

thero
01-23-2004, 10:19 AM
Hey look!
A Goodman plastic surgery job!

Musta been one good surgeon to make it look so decent.

Robo will be so happy! Make sure he finds out after he gets back from his honyemoon with Big Union Cleaning Mama.