PDA

View Full Version : twin boilers


tri-cityhvac
10-05-2003, 09:37 AM
http://www.imagewiz.net/images/hvac/184376_skyview_003.jpg
rich pickering
10-05-2003, 10:57 AM
That is nice.
mcfly007
10-05-2003, 01:00 PM
Nice job, is it my computer or is that flue pipe not pitched right?
sonc
10-06-2003, 05:04 AM
Tilt "Sputnik" to the left a little. There, that's better. Pitch looks good.
otto
10-07-2003, 08:19 AM
sweet
mattm
10-07-2003, 01:29 PM
Is that one of those cyclone deals to eliminate air on the right in yellow? If so how do you like them.
tri-cityhvac
10-07-2003, 09:32 PM
that is a 2" spiro-vent air eliminator made by spirotherm. it is a micro bubble absorber.all it is inside is a tight mesh of wire and the air gets caught in and sent to the top like any hy-vent.
markwolf
10-07-2003, 11:56 PM
spirovent works good IMO
oil-2-4-6-gas
10-09-2003, 10:18 PM
valves at the pumps--flow checks ---do not hold //everything gets wet when you have to replace them
gschra11
10-09-2003, 10:35 PM
What are those green things that are above each pump that has the pumps water going into the bottom and then going out the copper on the side?
bobby7388
10-11-2003, 11:39 PM
I like the extra stub for zone expansion if ever needed, good forethought.
Jultzya
10-12-2003, 12:13 AM
Nice work on both "TWIN BOILERS".

A few questions:

1.) why one have spirovent and the other has a standard air purger? (because of cost?)

2.) one threaded, one welded? (again cost?)

3.) is the expansion tank in the middle of the boilers?

Very nice work!!