tsuprano
03-03-2009, 03:33 PM
Hey all,
I was hoping someone might be able to help me through a situation on a Honeywell XBS system.
I was working on a project which uses Global Data Transfers and ran into the error show in the attached jpg file.
Basically what is happening is that when I go to modify an existing global data transfer point I get an error saying
Error reading command list from database
It will not let me perform any actions related to these transfer points at all. No deletion, no recreate and no changes.
Can anyone tell me a work around for this? I was thinking if I could find out which file XBS uses as the database I could delete it and start over. I have the information on all the transfer points so re-creation would be best. The other option would be a restore of an old system backup...this is impractical as I'm not sure when this issue was introduced.
Any help would be greatly appreciated....
Thanks again
I was hoping someone might be able to help me through a situation on a Honeywell XBS system.
I was working on a project which uses Global Data Transfers and ran into the error show in the attached jpg file.
Basically what is happening is that when I go to modify an existing global data transfer point I get an error saying
Error reading command list from database
It will not let me perform any actions related to these transfer points at all. No deletion, no recreate and no changes.
Can anyone tell me a work around for this? I was thinking if I could find out which file XBS uses as the database I could delete it and start over. I have the information on all the transfer points so re-creation would be best. The other option would be a restore of an old system backup...this is impractical as I'm not sure when this issue was introduced.
Any help would be greatly appreciated....
Thanks again