No Heat!

[arstacey]

I installed a new programmable thermostat last spring, a Hunter 44860. It cools perfectly but will not come on for heat. At the time I thought it was wired correctly, but cannot be sure now. It works perfectly if I switch it to cool. When I switch to heat, I cannot even get the blower fan to run. It is an electric 7-wire heat pump system. Here is how I have it wired:

Wire - Terminal - Usage
--------------------------
Yellow - Y1 - Compressor Stage 1
White - W2 - Aux Heat
Green - G - Fan Control
Red - RC\R - 24VAC
Brown - C - 24VAC Common
Orange - O - Reversing Valve Cool
Black - E - Emergency Heat

There are no jumpers, and there were none on the old thermostat if I recall correctly. Can anybody help me?

[Mr Bill]

Was there any kind of option on it to switch to gas or electric heat? other than that probably need to get a
service company out to help you figure it out.

[arstacey]

Yes, there is in the systems settings. It was originally set to conventional but I changed it to heat pump and it is set correctly for electric.

The heat worked last winter and the home is only a year old, so hopefully it is not the system :(

[Mr Bill]

I did not see you linked to another site in your post, I would go back and edit that, you can bet the Mods here
will not be happy to see that, just like to see you get off on a good start. :D

[arstacey]

I did not see you linked to another site in your post, I would go back and edit that, you can bet the Mods here
will not be happy to see that, just like to see you get off on a good start. :D

lol i didnt even think about that. i will edit it. just in a mad rush to get some heat and getting frantic lol

[HeyBob]

Sorry, this is not a DIY help site, you need to call a pro for help. Good luck, let us know what it was!