View Full Version : X-13 motor nitemare
12-10-2012, 03:24 PM
Anyone else having trouble with these x-13 gentech motors, all sizes so far that im seeing??:gah:
12-10-2012, 04:29 PM
We've had a couple of threads on this in the past. In short, yes, many, many problems. Personally I only use PSC motors when I replace them.
12-10-2012, 04:55 PM
Absolutely. I've replaced a TON. On all failures, check static pressure. I was told by my Carrier FSR that TESP should be below .6 to prevent failure.
I was told that if they run over .6, the motor will fail in 12-18 months in humid climates (I.E. South Carolina, Georgia, Florida).
All replacement modules should be remedied of this issue.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.