View Full Version : Jci fa unt111
11-10-2006, 11:52 AM
Anybody know were i can get some used ones?
11-10-2006, 03:14 PM
Here's where I get mine,,, try this
http://search.ebay.com/johnson-metasys_W0QQcatrefZC6QQcoactionZcompareQQcoentrypa geZsearchQQcopagenumZ1QQfposZ79311QQfromZR10QQfsoo Z1QQfsopZ1QQftrtZ1QQftrvZ1QQsacatZQ2d1QQsadisZ200Q QsargnZQ2d1QQsaslcZ2QQsbrftogZ1QQsofocusZbs
11-10-2006, 03:28 PM
Not to but in, but just be aware that those older UNTs with the "FA" prefix
were for the old Companion/Facilitator panels.
I don't believe they will work if you are planning on
hanging them on a NCM, N30, or an NAE/NIE.
Any of these front ends will require
one with an"AS" prefix.
If I am wrong here, then someone please correct me, but I believe that's how it rings out.
11-10-2006, 06:53 PM
It's slightly worse than that: the FA- controllers will only talk to a Facilitator panel (and perhaps the N31); the Companion panels used the AS- controllers, and wouldn't communicate with the FA-'s.
11-16-2006, 08:48 PM
UNT111 controllers with the FA prefix would only talk to a Facilitator panel and not a Companion. It was Johnson's way of dividing product lines from the Branches and ABCS's/Dealers. That was ill-advised and short-lived. Once you get to the N30 and/or NAE supervisory devices, all N2 devices are supported AS or FA or a mix on a network.
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.