dembones71
09-23-2012, 06:01 PM
hey everybody, I am more of a commercial tech but, I do some residential side-work. This project just so happens to be at the house where I rent my room. it's a rheem 10 seer split system with a gas furnace/air handler. after checking it out; i found that some of the charge had definitely leaked out. I replaced the schraders and a little 22. I know the inside coil is quite dirty so I can not be making any superheat calcs until that is clean. Unfortunately, with this set-up I have to pump down the line set, unsweat and remove the coil to clean the return (dirty) side. it is a cap tube system and it still has a visible charging chart based on outdoor dbt and indoor wbt. But the unit name plate is gone. I need to know the tonnage and such. I have all the compressor info if that will help. Copland Scroll 208-230V single phase, 60hz, Mot(Motor?) E, LRA 109.0, PLT 9. Any info is greatly appreciated.:cheers: