Another Vacuum Setup

[Txvman]

Three-way air manifold
2 - 1/4" X 3/8" X 3/8" vacuum hoses
1 - 3/8' X 3/8" X 3/8" vacuum hose
3/8" hand valve
1/4" port with shut off for micron gauge and to break vacuum with refrigerant prior to removing setup/putting on gauges

It all fits in that little red back to the left. On a small k-body two door freezer it pulled down to 500 microns in about 10 minutes. Took a half hour lunch and when I came back it was at 320 microns.

http://i199.photobucket.com/albums/aa53/Kodiakco/HVACR/photobucket-1511-1345079511428.jpg

http://i199.photobucket.com/albums/aa53/Kodiakco/HVACR/photobucket-11531-1345079493742.jpg

[SeanH]

I like that. I could use a set up like that for 3 point recoveries on ice machines. Where did you get the three way valve ?

[Txvman]

Northern Tools, Lowes also has them.

Sent from my DROIDX

[gravity]

you'd be better off mounting that 3 way valve to the pump and eliminating a hose. i would also put the micron gauge on the system side.

[Txvman]

I might have to check into mounting it to the vacuum pump. I don't want it on there permanently thou. I like the micron gauge where it is.

Sent from my DROIDX