Some more cool toolskis

[coolwhip]

I keep the in my drill case. Both are Malco products that work great!

http://img150.imageshack.us/img150/9185/cooltools1iv.jpg

[amickracing]

I bought myself one of them shears like that, but never really used it. Most of the stuff I do now is so small it's more of a pain to dig that out than just cut it with snips (most of our stuff is 26 ga).

Definately handy when cutting thicker stuff though!

I think I seen a double cut version of that too recently.

[coolwhip]

Those little snippys cut out the sides of furnaces like butter! screw carpal-tunnel syndrome, which I think I have a little bit.

[trane]

We used them on some 18ga duct on a RTU and was surprised on how well they worked.

[mark beiser]

Been using both of those for years, and have the big hole cutter too.

I find that I have to set the hole cutter a notch or 2 smaller than the size hole indicated on the scale, especially when cutting big holes.

The sheers are great when you don't need a perfect edge on something, especially when it is thicker than 26 gauge metal.