View Full Version : Drywall Mistake
tidefan
06-11-2006, 11:05 PM
Help guys!
What is the easiest way to locate a hidden HVAC register? Two story house, new construction, and drywall contractors covered up a few on the first floor.
hvac hero
06-11-2006, 11:36 PM
I've never had em cover up a boot, but they've covered up my thermostat wire a bunch of times. Did you use boot rails to put the boots up? If so, I would try getting one of those stud finders that find metal studs & see if it would pick up the boot rail. I've never tried this but it seems like it might work.
amickracing
06-11-2006, 11:46 PM
If you can access one end of the pipe that's hidding run some fish tape down it and listen for it.
The other option would be crank the a/c or heat way up and use an temp gun and shoot the wall looking for the hot/cold spot.
tinknocker service tech
06-11-2006, 11:46 PM
what was said already or turn on the heat or ac let it run for about half hour thrn run a infrared thernomiter along the wall til it shows the hot spots or cold ones
i had the do this once to find 8 unico outlets burried in the cieling worked like a charm
markwolf
06-12-2006, 01:20 AM
I was at a new construction job about fifteen years ago.I left 1/2 hand bent double hemmed drywall frame on everything that was to be cut around.I was lucky enough to be there when they started drywalling.The bozo's actually smashed my rings flat & covered registers instead of cutting around them.I told the drywall foreman & he oh well I guess you'll just have to find them.I came back with a 26oz.framing hammer.& I said really loud so he could hear.Well Jeff(My helper) I hope it was here or they will have to patch a hole.I took a big swing with the side of my hammer & WHOP!I busted about a four inch round hole with the side of my hammer.My helper laughed his butt off & said Boy you got lucky that time usually You miss Mark!(I knew exactly where it was we were f-ing with them)Thet guy said ok ok ok we will cut them out!!!I scared the heck out of him!Any way I would call the drywaller & tell them it is their responsibilty to cut out around registers & an add will be charged to the job if you have to do his job for him!!
Powered by vBulletin® Version 4.2.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.